how to load paper and ribbon in kodak 6850 printer

In this tutorial i will show you how to load paper and ribbon in kodak 6850 printer

1.

Slide the cover release toward you.

2.

Carefully open the upper cover.

CAUTION: The thermal head becomes extremely hot during normal operation. Do not touch it.

Note: The cover does not open beyond a 90° angle.

3.

Remove and discard the used ribbon. Remove the take-up spool from the printer. Push the take-up spool to the right. Remove the left side of the take-up spool from the spool holder on the left. Remove the right side of the take-up spool from the spool holder on the right.    Remove the supply spool from the printer.  Push the supply spool to the right. Remove the left side of the supply spool from the spool holder on the left. Remove the right side of the supply spool from the spool holder on the right. Discard the used ribbon. Note: Images remain on the ribbon after printing. If you need to maintain confidentiality, dispose of the used ribbon appropriately.

4.	Insert your fingers into the holes in the plastic on the end of the ribbon. Remove the plastic cover from the ribbon. IMPORTANT: Do not remove the wrapper from the ribbon at this time.

5.	Load the supply spool into the printer. Push the bar code end of the supply spool into the spool holder on the right. Place the left side of the supply spool into the spool holder on the left. Rotate the thumb wheel until the lugs on the spool holder lock into the notches on the supply spool.

6.	Remove the label and wrapper from the ribbon.

7.	Load the take-up spool into the printer. Push the right side of the take-up spool into the spool holder on the right. Place the left side of the take-up spool into the spool holder on the left. Adjust the take-up spool until the lugs on the spool holder lock into the notches on the take-up spool.

8.	If there is any slack in the ribbon, remove it by turning the supply spool.
9.	Close the upper cover by pressing on the center of the cover until it clicks in place.